This is an electric conversion for an RC10GT using a 540 size motor and 2s LiPo battery. The motor mount and battery are able to be directly screwed to the aluminum chassis using existing screw holes.

I used a "cheap" ESC combo from GOOLRC; 60A ESC with a 3900KV Brushless motor. The battery was a 4600mAh, 50C 2S LiPo and has enough power to spin the slipper clutch and run for about 15 min on a single charge. You'll also need a a couple of 3mm screws for the motor, the original screws to fasten down the 3D parts, and a 32p pinion gear set (16t,17t,18t,19t,20t). I think I finally settled on the 19t one.

Be sure to use ABS for the print because PLA kept compressing around the motor and the screws would loosen up.

FlashForge

Adventurer 3

Yes

Yes

0.18mm

50%

Google Sketchup for mounts, Battery tray from OM3