I printed this excellent set of relocation brackets: https://www.thingiverse.com/thing:3991856

This is a trivial remix allowing the original design to be used as corner braces elsewhere on the printer whilst keeping everything matching, because I'm OCD like that.

Added: top and bottom braces in a left- and right-hand version.

Edit for clarity of placement. The large brackets (corner brace) can fit in all four corners on the side faces of the printer, all four corners on the back face of the printer, and the rear two corners of the bottom face of the printer. The small brackets (top/bottom corner brace L and R) fit in the rear two corners of the top face of the printer and the front two corners of the bottom face of the printer. See additional photos.

Further edit: I suppose I should point out why I made them at all. When I put a (known true) engineer's square over the extrusions as supplied, each cut was an appreciable portion of a degree out from 90deg. So there was no way the frame was going together square, registering on the mis-cut ends. So I left all connecting bolts slack, installed these corner braces and pulled the frame square with them, and only just snugged up the connecting bolts.

Creality

Ender 2

No

No

0.2

20%