Summary

I wanted an XBOX 360 controller stand similar to agepbiz's XBOX ONE stand. I found a 3d scan of the 360 controller, but it doesn't allow for remixes, so I can't attribute it.

I made a rough stand and subtracted the controller from it in Solid Works. I tried to emulate the curves of the original, but the shear number of faces in the scan made working in Solid Works difficult.

The first print works and is a little tight. I may bump it to 101% or 102% and see if it fits a little better.

EDIT: 06/04/2024 - I made a V2 version with a longer base to be more in line with the original. I also bumped up the size of the controller scan to give a little more room on the base. It printed out great aside from a minor corner that I had to shave off before uploading it. I need to make two more and they will probably be V2's.

I added side-by-side images of the V1 (blue) vs V2 (red). The changes are small.