Print Instructions:

0.2mm layer height for multi-colour prints

For the hatched glass insert, you will need to print it multi-colour, with clear glass PETG and Black PETG

If printing with clear PETG check out this guide for how to get clear results:  https://www.printables.com/model/15310-how-to-print-glass

• summary: print it slow (15-20mm/s) and hot (260C)

• ensure adequate purge when switching from black to clear PETG

• colours can be drawn on to the insert with sharpies (tip: put insert in place upside down and use the lines of the lid to guide where to colour in)

Lid and Box were printed in Overture matte rock PLA

• print very slow on first layer and check to ensure it goes down successfully

NOTE:

• if you can not print multi-colour a blank insert is included

• if you do not have clear PETG print the "no insert" lid