Summary

Hello,
This is my first upload to thingiverse.
I basically took the Backpack gopro mount and added the M5 nut inside of it. I was having some trouble when I printed it that my GoPro screw didn't seem long enough to go all the way through to grab a nut on the other end. So I printed a few M5 nut from other files here and this one seemed to "grip" the screw (stock GoPro) the best. So I opened up Meshmixer and dragged it inside then tried to center it the best I could.

I am using a Creality CR 10
I usually use .1 layer heights and infill 20%. I'm sure you can go to .15 for the layer height. Yet since I am printing threads for the nut I wouldn't advise going to .2 or larger. I'm not saying it won't work. Just5 I haven't tested it.
Also this needs supports for the holes in the top of the model.

Works best with larger backpack straps.