If you want to equip your Planeprint Big Bobber with cosy seats, these files are for you!
The front seat is detachable by magnet-snapfix for easier battery change!

Cura settings for the seats:

• Planeprint profile P2 hollowbody
• Line Width 0.32mm
• Wall Line Count 1
• Top Layers 3
• Bottom Layers 1
• Infill 5% (Grid)
• Use Brim

Cura settings for the mounting brackets:

• Planeprint profile P1 fullbody
• Wall Line Count 8

Required accessories:

• 4 pcs neodymium magnets 5x5x5mm
• 4 pcs M2 tapping screws 4mm

Print the "rear_seat_extension_for_servomount" four times and glue them on top of the servomount. Insert the two brackets into the holes at the top and screw them tight.
Glue the seats with CA onto the brackets.

Pay attention to set the line width to 0.32mm for the seats. One should weigh about 13g. Try to print your 3D printed planes with 0,32mm in the future. This saves a lot of weight while maintaining the same strength!

You might have to mill something out of the bottom of the back seat and the rear bracket to make room for the servo arms and rods. Or you can scale the length of the brackets in the slicer, in which case the seat will be positioned higher, if it's OK for you.

Do not forget to fasten your seat belt! ;)

• 04.10.2020 Added alternative front seat mounting bracket part 1 with 5mm more height.

Creality

Ender 3

No

No