This is set of Domino in shape of Batman.

Files

• batman-domino.stl - one piece for tests
• batman-domino-X-Y.stl - dominos
• batman-domino-box.stl - box for dominos
• batman-domino-lid.stl - lid for box

Printing dominos

This is two color print, but there are only 2 changes per print, so it could be done manually.

Start with black filament. If you print with standard 0.2mm layer, first change to white/yellow should be done after 10th layer. Print 4 layers and then change back to black.

Important note on white/yellow filament - it MUST be very opaque. I printed it with white (Devil Design PET-G) because yellow one I also had (unknown maker) was not opaque enough to make good color after only 4 layers. Just test it on STL with only one piece.

Another note: pieces in STL are upside up. It should be printed with flat side on the bed :-)

Printing box

Box and lid should be printed in vase mode.

For box i used Devil Design's Galaxy Gray PET-G filament.

About

I used shape from https://www.svgrepo.com/vectors/batman/ and  modified it in Inkscape, then imported to OpenSCAD. Idea and the rest of work is mine.