This is a wall mounted hanger for brooms or mops. Push the handle in from the front and the lever pushes the handle against the grip holding it in. It has enough grip to hold up heavier items like a Swiffer wet jet. It is small enough to be printed on a 120x120 bed like a monoprice mini.

Print Settings

Notes:

The lever and grip need to be printed in flexable filament.

The grip is 100%

The lever is 25%

I printed the base with no supports. There was a little bit of layers sagging on the bottom, but by the time it got to printing the top layers it was solid. I printed at 50% but would recommend 100%. It dosen't use much more filament and makes sure there are no weak spots from bottom layers sagging. I printed at .1mm to get the best look for all the curved surfaces.

Post-Printing

The grip and lever are designed to be a tight press fit into the base. I clipped the bottom edges at a slight bevel to help slide in.

Category: Organization