A hard shell case to store Bubl camera to keep the lenses safe while stored bouncing around in my backpack.
http://bubl.myshopify.com/

Each half is a bit more than half the circle. The Bubl pops in and does not want to come out without a little push.

I shortened the overlap by 2mm than the version I am using to make it a bit easier to remove the camera.

This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/26NVvVEXbIz

Print the two halves separately with PLA.

It is hard enough to protect the camera but flexible enough to pop on and off the camera.

The first 10% of the wall is a little too horizontal needs to be printed slower than the rest. I printed at 50mm/s but slowed down the first part at the printer to 60%

I tapped the 1/4" #20 thread to keep it on the camera. I added a string to help pull it off the camera but the shorted halves should not need this.