A unique solution for utilising your drill press to its full potential, this design allows your compound vice to mount perfectly on the base of your drill press. You will need: A compound vice as in the pictures (this model is 105mm/4.25") 4x M12 x 50mm bolts 4x M12 Bolts 4x M12 washers 4x 7Gx25mm countersunk screws Notes *You need to print 2 lots of these files (one for each side) *Suited for drill press slots spaced 98-100mm apart from each other. *Some compound vices of this design have varied size tops but usually share the same base. Recommended Print Settings These settings are tested and printed with Cura V4.3 and Creality Ender 3. 1.75mm PLA filament 200 degrees C Extruder Temp 50-60 degrees C Bed Temp Scale : 100% ~6hrs print time (depending on your bed adhesion settings) Raft ( if desired) 8mm margin Infill : 50% Layer height : 0.2mm perimeters : 7 Speed : 50mm/s