A charging stand for the Huawei Watch. Based on beavertank's "Minimalist Huawei Watch Charging Stand - Mk. 2" with the following changes:

• Watch is centered on the holder, not way off to the edge
• All parts are filleted using wide compound fillets
• The shelf for the watch is thinner and has a flat cross-section, not triangular, for a cleaner look
• The base contains openings for inserting 8 US quarters, 50 euro cent coins, or (with a bit of sanding) British 20 pence coins.
• Cable channel is slightly narrower to better hold the cable in place

Very little post-printing finishing is needed. The coins are inserted in the bottom. At least on my print, they were pretty snug without any adhesive, but I covered the bottom with masking tape (as shown in Post-Printing) to prevent the coins from coming loose or scratching my night stand. It's almost impossible to knock over accidentally with over 45 grams in the base. I also put some self-adhesive felt on the top of the base (as shown in Post-Printing) to protect the dangling watch band from getting scuffed if it is left unclasped.

Print Settings

Printer Brand:

MakerBot

Printer: 

MakerBot Replicator Z18

Rafts:

Doesn't Matter

Supports: 

Doesn't Matter

Resolution:

0.1-0.2 mm

Infill: 

10%+

Notes:

Printed with 4 shells for added durability when inserting the charging puck and coins.

Printed with the large flat side (with the cable channel) facing down against the printer bed.

Post-Printing

Side (bottom when printing) sanded down, and self-adhesive felt added to protect watch strap.

Huawei Charging puck inserted in the top.

Cable routed through the cable channel.

8 US quarters installed in the base. You can also use 8 50 euro cent coins or (with a bit of sanding) British 20 pence coins.

Masking tape to hold the quarters in place and prevent scratching.

How I Designed This

Based on beavertank's "Minimalist Huawei Watch Charging Stand - Mk. 2". Recreated and modified in Autodesk Inventor.

Category: Gadgets