,Yet another towel holder.. but this time with clear hygienic signs to avoid mixing up the towels intended for your face, hands and body – ladies and gentleman’s. Use double-sided tape to mount on your ceramic tile wall. The face-, hand- and bodyholders comes in two variants – with a regular hook or with a “claw” preventing the towel to slip off when pulled in an angle upwards. The claw design needs support from 45-degree overhang. Remove the support with a needle pliers. Just fuse the suitable pieces together in your 3D-printer software, rotation of the pieces when you import them may be necessary. For best results when 3D-printning Use a layer height of 0,1mm. Suitable printing materials: PLA tough or regular PLA. If your printer has build plate adhesion problems, use a brim. Scale it after your needs, original height: 65 mm, width 40 mm.