This project is the result of more than 100 hours of renovation and printing.

There weren't any miniature handheld gliders before that could be printed out in less than half an hour and thrown directly. I want to change that.

The main feature of the glider is its unparalleled accuracy and consistency, allowing skilled users to lift the plane 30 feet into the air before dropping it just one inch.

Pitch stability, yaw stability, ease of use, consistency, durability, and flight time.

★★★★★ ★★★★★ ★★★★ ★★★★★ ★★★ ★★★★★

It was printed on the Bambu P1P using white PLA base material. The printing took 23 minutes

Explanation -

Printed with PLA, the infill rate is 100%, and no base or skirt is needed. After the hotbed cools down, gently remove the glider with a scraper tool.

Bend the rear part upwards by 90 degrees.

Bend the elevator downward by about 25 degrees and flip the plane over.

Hold the glider between the main wing and the tail wing with your hand and throw it gently. When throwing, the tail part should be facing down and the elevator should be facing up. If the plane seems to tilt to one side, try throwing the plane with more force.

If the design is placed at an angle, it can be placed on most printing boards. However, if it doesn't fit, please print the left simple indoor glider V2 and the right simple indoor glider V2 separately, and then glue them together with hot melt adhesive or a 3D pen. Tape or rubber bands can also be used.

If you want the plane to look better and land more smoothly, you can reverse the tail wing, but the performance will slightly decrease. Just make sure that the weight of the front part of the plane is downward to increase stability.