**MARCH13, 2019 UPDATE: As mentioned in the comment by "socratesjohnson" I have confirmed that the Stabilizer V1.0 file is incorrect. I have removed the file from the list and have updated the "Things File" with the correct file "Fume Extractor Stabilizer v1.1".** Sorry for the mix up.

This Soldering Fume Extractor is made for a 80mm 12v computer fan. I made the design
with a couple of options. You can mount a toggle switch to power on the unit if you
decide this is the route you want (I powered my unit using a 12V 1Amp DC 110v PSU I found on Amazon.ca). If you decide you want to add/design your own switch mount then you will want to print the file that says "without switch". The other option is the front grill
which is flat, the other has 4 sides that flare out at about a 10 degree angle, Personally
I just went with the flat design, not so sure the other design will be effective.

Items you need to complete the build:

80mm Computer 12V Fan
Optional Toggle switch to power on/off the unit
Carbon Filter (Found on Ebay and cut down to size)
1.25-1.5" bolts with matching nut (2x)
Computer Mounting Fan screws (x2)
4 smaller type screw no exact size I just used what I had on hand but probably
a m2.5 or m3 will be fine, Trial and error it.
12v PSU 110V plugin, I just bought a 5 pack from Amazon.ca for $20.99CDN Link below. ( https://www.amazon.ca/gp/product/B00FEOB4EI/ref=oh_aui_detailpage_o00_s00?ie=UTF8&psc=1 )

As an option you can also power the fan using a 12v (3s) Lipo Battery with a JST or XT60 connector depending on your battery.
Some basic soldering skills are also required to complete the build.

Comments are welcomed

Anet A6

No

See Below

See Below

FumeExtractor V1.0 With_Switch---Layer .20 Infill 40 Yes Supports *Updated March13, 2019
FumeExtractor Switch V1.0---Layer .30 Infill 30 No Supports
FumeExtractor Stabilizer V1.1---Layer .30 Infill 30 No Supports
FumeExtractor FilterFront Ext V1.0---Layer .20 Infill 20 Yes Supports
FumeExtractor Fangrill V1.0---Layer .20 60 Infill No Supports
FumeExractor V1.0 Without_Switch---Layer .20 Infill 40 Yes Supports
FumeExtractor JST_Switch V1.1---Layer .30 Infill 30 No Supports Added July 8, 2018 to allow you to mount a permanent male(casing) JST connection to the unit and then solder a female(casing) end to your PSU cable