Okay, so I don't know what to call this thing, but I have found it pretty useful so I thought I'd share. I needed something to hold a single small tool to my pegboard.

In this case it was the little grabber thingy from my tool kit - you know? The thing you pick up screws with when you drop them somewhere you cannot reach.

Turns out, this also holds screw drivers and other single shaft tools as well. (see pictures) I have the rack types already for my driver sets, but I still had a couple rogue tools that need to be organized. So, I use this now.

I know it's super simple, but like I said, I've found it pretty useful. Also, you can use up the little amounts of filament you have left at the end of a roll on small things like this. ;)

Note: The middle does get a little stringy if you print without supports, but I prefer this as the few strings you do get are a lot less material than the supports will waste. Also - print in the orientation of the file. If you lay it on it's side you'll mess up the pegs which are more difficult to clean up and which need to be more accurate.

Doesn't Matter

No

I didn't use supports because the small strings that do go rogue are easier to clean up than the supports are. So, I print these with no supports. If you're a perfectionist, you may want to use supports.