This hanger will hold common pistols. If printed correctly it will hold a handgun snugly. It takes four #8 screws to mount to wall. The left hook slides in to left side and right hook into the right side. It may take some force, I made it a snug fit. Position where you please.
Insert 1, m3x20 screw into the top hole of each sliding hook hole. Use screw nuts to fasten
(dont fasten to tight) and thats it. It may not fit all handguns perfect but the pistols shown in the pictures fit well and wouldnt fall out if bumped into. This is a work in progress and my next plan is to make angled hooks for the mount.

(i didnt adjust the fit on bracket to each handgun. given enough time each handgun in picture could be fitted better than whats shown, the dovetails to the Kimber 1911, and Beretta M9A3, were holding it in place well enough)

Side note: None of the screw holes on hanger itself needs supports. The only supports i used were for the lips of the hanger and for the screw holes on each hook. You can use support blockers to block the hangers screw holes, Just make sure to not block the track lip support.

You will need to print.

1. left hook
2. right hook
3. wall hangar

this thing is nearing 200 downloads. id love to hear some feedback. what handguns are you using with this hanger? do they fit well? any recommendations? if all is well, id love to see pictures of your guns on it.

Creality

Ender-3 v2

Yes

.2

50%-90%