Overview

This is a splitter that has already been released, but the difference is that it is not fixed with a magnet, but with M3 screws on the existing threads. It has two versions: one is flat, and the other rotates an arm 90° toward the spool direction for better wire storage. At the entrance to the printer, I used a sharp knife to slightly widen the PTFE tube toward the AMS direction to improve the feeding process. The existing M3 screws need to be replaced with longer ones.

• PC4-M10 pneumatic connector, inner diameter: 4 mm
• 2x M3 6mm

Translated with www.DeepL.com/Translator (free version)

A splitter as already presented here, but not with magnets, but fixed with M3 screws to existing threads. It is available in two versions. Once flat and once with an arm rotated 90° towards the coil, in order to better accommodate the filament here. At the entrance to the printer, I slightly widened the PTFE hose towards the AMS with a sharp knife to improve the entrance. The existing M3 screws need to be replaced with longer ones.

• PC4-M10 pneumatic connector, inner diameter: 4 mm.
• 2x M3 6mm