Fun fidget type box to print!

Modified https://www.thingiverse.com/thing:33296 to make it wider. Added registration points to more easily allow for assembly/glue up to ensure parts are correctly aligned to prevent the cover from lining up crooked upon closing. Also made the groove to retain the cover much deeper (3mm extra on each side) to prevent the cover from coming out of place.

Print instructions are the same as the version this was remixed from. Main things to focus on in your slicer:

1. Orient the cover in a way that the first layer lines run perpendicular from the handle direction (front to back of the cover to prevent the cover cracking)
2. If scaling ensure that there aren't more than one layer for the cover (aside of ridges and handle obviously)
3. Do not use a raft for the cover - it will most certainly break upon separation.

On my personal Ender 3 Pro I used the following settings in Cura using Microcenter pla
200c nozzle
60c bed
100mms speed
50mms wall speed
10% cubic infil

No supports necessary!

Original Design Creator : gabrielfp
https://www.thingiverse.com/gabrielfp/designs