The Christmas decorations from your favorite plumber!

If you want to support us, make sure to give us a like and subscribe
to our Patreon! https://www.patreon.com/Zprint

-Might need supports for some parts.
Tree supports should do well, when printing this on a 0.2 layer height (make sure to put an air gap of 0.4 for easier removal of the supports).

-Copy and paste the eye and mirror it in your slicer for them to fit in their gaps.

-Might need some supports on the flower's stem

-You might get scaling problems on Cura Slicer, if that's the case, just set the overall scale to 100000%