Print with a layer height of 0.08mm, a base height of 0.16mm, and a 100% infill rate.

The model size is 200x121.67mm.
You can use a higher layer height for printing at a minimum depth of 0.48mm or less.
The maximum depth is 2.2mm, and the actual depth is 2.3mm.

Consumables used:
PLA PolyLite Black, Transmission Distance: 0.3
Bambu Lab PLA Basic Blue, Transmission Distance: 4
Bambu Lab PLA Basic Red, Transmission Distance: 4
Bambu Lab PLA Basic Orange, Transmission Distance: 7
Bambu Lab PLA Basic Yellow, Transmission Distance: 6
PLA PolyLite white, transmission distance: 5
This print uses six unique consumables.

Instructions for replacing consumables:
Start with black
Replace it with blue on the 8th layer (0.72mm)
Replace it with red on the 10th layer (0.88mm)
Replace it with orange on the 12th layer (1.04mm)
Replace it with yellow on the 17th layer (1.44mm)
Replace it with white on the 21st layer (1.76mm) until the printing is completed.