Version 2 has been released, bringing a host of improvements!!

Check it out here -https://makerworld.com/zh/models/1536377-dummy-13-locking-stand-v2#profileId-1611814

We've added locking points, so you can lock it at positions that are multiples of 45 degrees.

It enhances the durability of the stent in maintaining its position; it seems to be much better than the original version

It should be printed with a layer height of 0.15 mm

Printing this with PETG or better materials works great, but you can't use PLA

This applies to all original adapters of the entire 13-series

You can find these in the print configuration that is marked accordingly

AttentionYou don't need all the extra arms, just one; I made a few different types on a whim