For the NX3224T024_011 (2.4 Basic Nextion)

Important notes
--The project I meant this for did not need both Tx and Rx from the Nextion. If you want to wire 3 buttons, and the entire Nextion, you cannot do it with the 6 pin JST connector this was intended for, unless you find something else that works.

--There are no standoffs or anything for the buttons or screen. I hot glued the buttons in while putting a small dab on the corners of the Nextion PCB.

--I had a tight fit for the Nextion and sanded a little bit of the case wall.

General settings:
I used generic PLA settings for the Ender 3 Pro and it turned out just fine. Nothing too crazy!

Supports:
To maximize the quality of the face, print screen side up with supports (this is how I did it), otherwise however you feel is ok!

Raft:
Not needed unless you want to anchor the supports if you print that way :)

Creality

Ender 3

Doesn't Matter

Doesn't Matter

200

8%