My Flashforge AD5X setup called for a front facing IFS mount to be inline with my dryer box.  Nothing was quite matching what I needed, so I designed one in tinkercad.  Once installed, it was clear that the IFS cable needed to shift to connect back to the IFS.  I created the new horizontal IFS cable clip that allows enough slack for this to happen.  Both of these use the screws included with the existing AD5X setup.

Settings for my print:

• PLA

• .20mm layer height

• 20% Infill

• Supports on

If interested, here are the links to the dryer box and the additional PTFE tube and fittings.

Dryer: https://a.co/d/0e37iFX3

Tubing and fittings:  https://a.co/d/0fTRAOg2