Update 11/08/25: Thank you very much, user SerialD3. I messed up the updated part. The Mid V3.stl should be correct now.

Update on July 25, 2022: The size of the screw holes in v2.stl has been reduced to 2.79mm to increase the holding force of the screws - inOriginal model fileDownload section.

Yes, that's right. This is a traditional pie-shaped Raspberry Pi 5 case.

It is also suitable for active coolers and NVMe boards with built-in storage space, which can accommodate 5 micro-SD cards.

I printed all the parts at a layer height of 0.28 mm, with 10% linear infill. The bolts and reset switches are erected on the flat wide end, with a 5 mm edge and a 0.1 mm gap, so they won't collapse. When you first screw in the bolts, you should also loosen them a bit. Screw them back and forth a little, especially when they're almost fully screwed in.

Mmm.. delicious raspberry pie..

My PATREON and PATREON store.

https://www.patreon.com/3DFreeman

Thank you for your continuous support!

Source of the original pie chart:https://www.freepik.com/ 

The source of the Raspberry Pi logo: https://www.thingiverse.com/thing:281122

Import Blender and then perform edge tracking on the lines. Thank you so much, RockWave :)