Here is some genji hueforge i make. i used for the picture sunlu pla not the fillament in the describe it came out pretty good i think.

Project: genji green.hfp

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

 The Model is 112.5x200mm in size

 You may print at higher layer heights below the Min Depth of 0.48mm

 The Max Depth is 2.2mm and the Actual Depth is 1.8mm

Filaments Used:

 PLA PolyLite Black Transmission Distance: 0.3

 PLA BambuLab Basic Blue Gray Transmission Distance: 3

 PLA+ Sunlu Green Transmission Distance: 10

 PLA PolyLite White Transmission Distance: 5

This print uses 4 unique filaments

Swap Instructions:

 Start with Black

 At layer #8 (0.72mm) swap to Blue Gray

 At layer #12 (1.04mm) swap to Green

 At layer #13 (1.12mm) swap to White for the rest.