Simple dragon hueforge bookmark.

Project: dragon bookmark.hfp
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 51 x152 mm in size
You may print at higher layer heights below the Base Thickness of 0.48mm
The Max allowed Thickness is 2mm and the Actual Thickness is 2mm

Filaments Used:
    #000000 PLA BambuLab Basic Black  Transmission Distance: 0.6
    #646c74 PLA Copymaster 3D Grey  Transmission Distance: 1.5
    #0086d6 PLA BambuLab Basic Cyan  Transmission Distance: 3.5
    #ffffff PLA BambuLab Basic Jade White  Transmission Distance: 5
This print uses 4 unique filaments

Swap Instructions:
    Start with Black
    At layer #8 (0.72mm) swap to Grey
    At layer #10 (0.88mm) swap to Cyan
    At layer #13 (1.12mm) swap to Jade White for the rest.

The learning curve is real, so any likes, comments and boosts are greatly appreciated!