These are remixs based on openGrid snaps to let users attach double sided tape e.g. command strip and attach openGrid to the wall.

In addition, you could attach multiconnect screws (Included in all print profiles) to all snaps thus you do not lose a grid slot just for wall mount.

If you do NOT need multiconnect thread, please try this https://makerworld.com/en/models/1376708-opengrid-adhesive-wall-mount, it take less time and less filament to print.

There are 4 versions, 1 print profile for each version

• Version 1, single snap
  • For mounting single or multiple grids to the wall on edges
  • To use it, please make sure the arrow is facing up, thus the top of openGrid will be secured and can only be snap off from bottom and side.
  • Suggest to use 4 per 8*8 or bigger size grid and when removing please snap off the bottom ones firstly.
  • 4 foldable multiconnect screws included
• Version 2, double snap
  • For connecting and mounting 2 grids together to the wall.
  • No directional
  • 4 foldable multiconnect screws included
• Version 3, tripple snap
  • For connecting and mount 3 grids together to the wall.
  • No directional
  • 3 foldable multiconnect screws included
• Version 4, quad snap
  • For connecting and mount 4 grids togher to the wall.
  • No directional
  • 4 foldable multiconnect screws included
• Version 5, single snap alternative
  • For mounting single or multiple grids to the wall at bottom of grid
  • This version was requested to have the wall mount part hidden when using at bottom of grid.