Haven't printed this just yet. Rough model based on a fork that was missing the cover. This model is for the Giant Animators, and Liv Adores with the plastic forks. No clue if it fits any other models. If you wanted, you could probably print solid as opposed to as a shell and it should basically fit the same. I hold no responsibility if you damage your own, someone else's, or especially one of your customer's bikes. May the odds ever be in your favor.

** Printed it to test, length is slightly short, but the hole lines up. The angle of the chamfer is also slightly more shallow than original. If I have time I may revise those two parameters later. The hole lines up ok, and the width is ok.

Category: Sport & Outdoors