Summary

I created couple simple home replacement parts.

Tea Pot hande

My original wooden/rattan perished and it was surprisingly hard to replace - it had two small nobs instead standard one. I printed it first from grey-PLA at 0.3 with fancy scale in both y and z. (grey one) that was very hard to place on heat bed so I went with simpler white version (PET).

Watering rose

I wanted to use PET and on my MK2 it is tricky to print small details (holes in watering rose) so I limit number of holes so first layer stick properly wattering_rose_v3.stl. It works pretty well but I used hand drill to add couple more holes for faster watering.
For next one (v4) I add fancy ring and create it much bigger. Print went super-nice with 0.2+white PET

It is possible to customize size, angle, number of holes. I am aware that angle of holder will sink too down to the rose and couple layers will be printed in the air.