You can use any print settings as you desire, but these are the ones I used.

 

Perimeters | 3 Layer Height | 0.10mm Infill | 80% Cubic Supports | None needed! Nozzle Size | 0.40mm

 

Hardware Used

 

M3x12mm M3 Threaded Inserts (Optional) 6 * 6x3mm Neodymium Magnets Raspberry Pi CM4 Waveshare Nano Board (C) for CM4

 

You can use any soldering iron to melt the inserts in, I personally like using my Pinecil soldering pen for this.

I just printed this and I don't 100% like this but it's a solution. One thing I did that I do recommend is once you have everything setup and you don't need access to anything else for now, I got some super glue, put it on top of one of the cracks, and used some plastic to spread it out, and now it doesn't move. Sure there were other ways to make this but this is just V1. Let me know if you have any recommendations for V2.
 

******************************************************************************

 

I’m a high school student who enjoys 3D modeling as a hobby. I primarily use Shapr3D for my creations, and I truly appreciate anyone who downloads my models, sells them, or remixes them. Feedback for future projects is always welcome. You are welcome to ask me for model requests and I will try to the best of my current abilities to fulfill your requests. You can ask me any question and I'll respond as soon as I'm available. Feel free to ask me for any alternate file types if you'd like to alter my models.

Thanks,
Xalibre (just an alias)