I needed a way to get three obnoxiously sized (under corded) wall warts plugged into a single outlet. What I had on hand was a three outlet Bull “Power Strip UU1153”, which would get the job done if it didn't require a free surface to set it on. So I whipped up this mounting bracket.

The back wall is a littler thicker than necessary in order to give 5mm of extra wall clearance for wider plugs.

Hardware

• 2 mounting screws (flat or trumpet head)
• One of the power strips

Print Settings

• Layer Height: 0.2mm
• Perimeters: 3
• Infill: 15%
• Supports: None