Replacement hinge & pin for an Atari 810 Tandon Floppy Drive Door.

Installation instructions:

Place the hinge on the door between the pin holes. Thread the pin through the holes and hinge. The pin should fit snugly in the holes, but turn freely in the hinge. If either doesn't fit as planned, you might have to adjust the diameter of the pin per your printer.

Now push the drive armature down and install the door & brass door slide pin. Carefully close the door with the hinge on top of the screw holes, and place the metal drive door part over top the hinge (you have to hold everything together with pressure from the top, take your time and figure it out, not too difficult once you get the hang of it.) Now assemble using the screws. Done!

Creality

Ender-3 v2

No

No

.2

20%

Print the pin at 100% fill, hinge at %20