This is mount that makes it easy to use a set of EasyLights on more than one plane.
The original was strictly magnetic but I've had issues in the past with a magnetic FPV camera mount getting knocked off the top of a RC car, so on this light mount I decided to use locating pins. A link to the original design is below. This design uses 8mm x 2 mm magnets. Harbor Freight sell some that are listed 5/16 x 1/8, they work too.

Creality

Ender-3 S1 Pro

No

Yes

0.20 layer

yes

The pins on the top are made to break off flush.There is shape(you can use as a void area) included so it's easier to design your own mounts. I use rubber bands to secure the light to the mount but I also included a version without the rubber band ears. The one with rubber band ears needs support under the ears.

The pins are made to be broken off the top piece and glued in the holes of the top piece. This keeps the mount from sliding off the base.

The photo hopefully is understandable. The magnets are made to go in from the opposite side of where they stick, this is to help with gluing them.

This design uses 8mm x 2 mm magnets. Harbor Freight sell some that are listed 5/16 x 1/8, they work too.

The original files were posted on Printables by "Malatoke", I sent him a message asking permission to remix and post this on another site, and he did say yes.
https://www.printables.com/model/459312-easylight-magnetic-adapter-for-rc-planes