Material choice:
Tube: petg - so it is slicky

Lid: petg/abs - generaly it can be whatever

platform: abs/pla - you generally want to payload to stick to it

screw: petg - also slicky , use brim

dial: petg/abs -  (it has bendy teeth, which may break if it is from PLA)

print params:

0.2 layer height (you may go with finer around lid thread)

0.4 nozzle

shell thickness 1mm

2 walls

smooth plate (except platform, where use textured)

completing:

insert screw from bottom, snap off hanger from dial (could be used for vapour smoothing or whatever), position (with screw) dial on bottom and snap it into tube. it would not snap in if screw is not positioned correctly.

insert platform from top, flat side up. turn dial counter clowise, untill platform gets to bottom

enjoy