I had some TPU and no Sorbothane so I created some simple models to work with your design and the design that mentioned the larger pads. It really quieted the machine.

I printed them with 0 infill and tried both 3 shells and 5 shells. I liked the 3 shells better since it had a bit more spring to it. (I'm no material scientist so I'm not sure if more or less give is better for this application.)

Printed with Amazon Basics Red TPU.

0 infill

20mm speed on every settings.

235c first layer, 225c other layers.

Category: 3D Printer Accessories