This OpenSCAD script creates a holder for an STM Gyro Eval Board that fits onto the moutign holes on a Gyro_Turntable_Mounting_Plate so that it can be tested on a high speed turntable

Note:
may need to trim some stuff from the top of the cylindrical posts as there are many small components adjacent to the screw holes

Changes from previous versions:
v0.4

• removed one of the bolt holes under devices
• make it thicker (from 3 to 5 mm) so it prints better
  v0.3
• adjusted some values based on callipers based measurements of board
• now it should be realistically sized
  v0.2
• removed junk lines
• added cutouts
• repositioned parts
• added minkowski sum to round out corners under PCB
• made it into a printable item
  v0.1
• first attempt at laying out parts

1. Build High Speed Gyro Testing Turntable :p
2. Print and cleanup holder
3. Attach STM Gyro Eval board to holder using wood/plastic screws (redrill screw holes in holder if necessary
4. Bolt to Turntable using supplied bolt holes in correct orientation
5. Test Gyro to its limits