The stock FPV camera mounting option does not go beyond approx 10degrees. This is a mount design that lets you mount it at 20 and 30 degrees.

Print Settings

Printer:

Prusa i3 Rework

Rafts:

**Supports:**

No

Resolution:

**Infill:**

20-30%

Notes:

Print 2 of them. One normal and another mirrored.
the*_WS version is with manually added support.

Post-Printing

The stock screws should thread in just fine. The camera mounting screws might show stress on PLA. Relieve stress by exposing to a small gas flame for a short while.(the white marks should disappear)

Category: R/C Vehicles