Had a request to print a vinyl and a mounting display for a shelf. The customer is using it and will make a sticker using a cricut to make custom vinyls for their display shelf. The vinyl is the size of a 45 (7 inch diameter), but is thicker than normal (0.1 inch) since it's just for display. I found this vinyl model and scaled it to the requested size. Then used Tinkercad to quickly make a simple mount. The vinyl was made to a negative volume and thickened a little to allow it to be placed easily and cleanly inside the mount.

Creality

Ender 3

No

No

0.12mm (vinyl), 0.2mm (display)

100% (vinyl), 30% (display)

Because this was going to have a sticker placed on the center, I did have to sand the center of the vinyl to get a nice smooth surface for it to stick to.