Introduction

I created this ring to fix your SingingFriend feedR when the part the birds sit on breaks off. This happens when a large or (too) chunky bird sits on this part. Glue, caulk or duct tape without any additional support (which this ring provides) will only get you a temporary fix (trust me). As I'm (currently) a complete design noob I designed this in Tinkercad.

How to use

1. Print this model (<15 minutes).
2. Use glue to reattach the broken off part (5 seconds).
3. Wait for the glue to dry (30 seconds).
4. Attach the ring using glue (5 seconds).
5. Optional: wait for the glue to dry in order to prevent any birds from sticking around too long. ;-) (30 seconds).

Print suggestion

• Filament: PETG-G
• First layer: 240° hotend temp, 80° bed temp
• All other layers: 230° hotend temp, 70° bed temp