This is a simple design I created to solve a single problem - vertically mounting an APC zero-U PDU to my StarTech 42U four-post rack.

This bracket attaches to the top and bottom horizontal rails using the four bolts that set your rack depth. Remove the two black plastic discs from the rear of the PDU and use the countersink screws to attach the PDU to the bracket.

For best results, I recommend printing with 100% infill. The end result is only around 40g for both brackets, so I felt it was worth it for the added strength.

Creality

Ender-5 Plus

No

No

0.2mm

100%