I recently replaced my electric car that used a type 1 inlet with a car with a type 2 inlet.
This meant replacing the tethered cable on the Rolec Wallpod charge point with a type 2 cable. There are commercially available equivalents of this, but I had filament and a 3D printer, so I designed my own. Bolt fitments are the same as the original Rolec type 1 holster.

Featuring a water drain on the bottom, and a retention clip.

Needs supports during printing or the retention clip won't work.

ABS filament recommended for better resilience to the outdoors. Include a raft to avoid ABS warping.

Prusa

I3 MK3S

Yes

Yes

0.10

40%

Support is mandatory. ABS recommended for sunlight resistance.

There's likely to be support material around the retention clip and the drain holes on the bottom (inner and outer)