Summary

This is a remix of a part because I wanted to be able to print it without using supports. This is the main body part of the blaster but split down the middle so the two halves can be printed flat, which in my case reduced the print time by half. As an added bonus, you can turn ironing on when you slice the parts for a better top surface on the mostly flat sides of this part.

Both halves can be printed at the same time on a build plate of at least 220x220mm.

All credit for this part should go to it's respective creators who came before me. All I've done is make one model into two for ease of printing.
I may add more models to this listing at some point as I am currently printing the blaster myself.

Update 5/16/25: I created a second version of these models that features some holes and index pins to make aligning the two halves much easier when gluing. If you print the halves with alignment holes, four index pegs should also be printed. In my case, supports were not needed, these holes are only 1cm across at the widest point and I didn't have any issues bridging them.

Update 5/17/25: added a few pictures of the parts.