Summary

Just a simple holder for the adapter that lets you use sd cards in a microsd socket
from http://www.dx.com/p/sd-to-microsd-transflash-card-converter-module-27001
as doublesided tape is not cutting the mustard.

I've included the 123design file in case you want to add countersinks for the screws

it's setup for M3 screws and I would recommend a bit of sticky behind the adapter to stop upward movement.

It should lay down for printing upside down as then it will print without any supports.

Note when I sliced this with cura 2.40 it sliced wrong but was fine with slic3r