My Sharp vacuum cleaner brush attachment holder broke and no replacements are available from Sharp. So, I drafted this attachement holder. I slips down and around the neck after releasing the handle. Then, the brush attachement is held conveniently in place by a slight pressure from the sides of the "prongs" as shown in the accompagning images.

Creality

Ender 3 Pro

No

No

0.2

30%

No rafts, skirts, supports were needed. The part might be prone to eventual wear from slipping brush attachement in and out of the holder. But, so-far-so-good. Beats buying a new vacuum.

This was my first attempt at precision modeling. I realize beveled edges would make this part more visually pleasing. Perhaps on the next Thingiverse object I create that will be taken into consideration.