This is a remote-control holster for the Motosleep bed height controller. I printed in PETG, but this should print fine with PLA as well. Should be printed upright. For some reason it's exporting the model lying on its back.

I printed two of these, one for each side of bed. One side I printed at 0.2mm layer height, the other at 0.12mm layer height.

My printer struggled a little with the bottom layers adhering for some reason until I added a decent size brim. Might have been something to do with the fillet I added to the bottom of the model.

The remote fits snuggly, but still loose enough to slide in and out with ease.