This is a simple silverware drying container insert designed to be used in conjunction with a dish drying rack. There's several slots and grating to accommodate higher airflow and drainage. This piece should easily slot over the top of most wireframe drying racks

Currently the print is in progress, will post photos after it completes.

Creality

Ender 3

Yes

Yes

0.3

20

Printing bottom down is likely to be the best orientation. With 0.3 resolution, 20% infill and supports enabled(which is required for this print) it's estimated to take over 24 hours to print on my setup. Your mileage may vary.