I made this as a model for my National History Day project in school. I managed to print it, though it took a few tries. I recommend using a resin printer, though, since most of the overhangs are very difficult for a FDM printer to take.

NOTE: The GCODE included is fit for a reality cr-10s pro/pro v2, though i am not sure if other printers can use the Gcode.

Creality

CR-10S

Doesn't Matter

Yes

any, depending on what you need.

25% to 75%

I'm not sure how I managed to print this, but if it doesn't work for you after 2-3 prints, give up. It took me 45 tries to get a successful print on 25% speed, 65-degree bed temp, glue, and a higher nozzle temperature.