A base for a ESP32-C3 and led ring to turn your Napstablook light into a smart wled light.

Parts:
ESP32-C3 (Check the picture to make sure you grab the right one)
16 Bits 5050 Rgbw SK6812 Led Ring (~45mm)

Assembly:

1. Remove the power LED from the ESP32-C3 module
   If you skip this step, there will be a faint red light that stays on.
2. Solder the LED module to the ESP32-C3
   Try to keep the wires nice and short to avoid shadows.

Connections:
GND → G
5V DC → 5V
Data Input → 2

1. Flash the WLED firmware to the ESP32-C3
   After flashing, configure the right LED type in the WLED web interface and test to ensure everything works as it should.
2. Glue the ESP32-C3 in place .
   I used hot glue so it can still be removed easily if something ever breaks.
3. Glue the LED module in place.

No

Yes

0.2mm

10%

PLA

White