Handle for a generic small slow cooker.

the one that came with it broke into pieces. more like crumbled into pieces.

slow cooker has a diameter of 21.5cm
mounting holes are 4cm apart.

highly recommend to use ABS since it will probably get hot.

but since i don't have an enclosure, the ABS print was unusable, was too brittle. (brown version in the pictures). ended up printing one in Red PETG, until i can build an enclosure for my CR-10S Pro.

04/09/2019
well PETG melted.... ir temp says that the cooker was getting up to 150°C ...
reprinted in ABS, and line the part that makes contact to the cooker with a small layer of silicon to act as a heat-break . working so far....

FreeCad File included

Creality

CR10S PRO

Doesn't Matter

No

0.2

20%

highly recommend to use ABS since it will probably get hot.

make sure to use more Wall Line for strength, i used around 6 - 9