Update:

I added a new version with a bigger hole in front for easier access to the MicroSD card.

I wanted a way to mount my Raspberry Pi 3 case running OctoPi onto my Maker Select Plus printer that would be out of the way.

You will need to use a couple of zip ties to strap the Raspberry Pi case in the back. This will keep it secure while still allowing you to remove the case or the case top (I put the zip tie between the case and the top). I also left an opening in the front to allow access to the sd card.

You will need to replace the stock screws for the filament holder with two M5 10mm bolts.

Monoprice

Maker Select Plus

No

Yes

0.2mm

5%